General Information

1. PVC molded fender that is 6" wide and over 36" long.
2. Upper attachment system which hooks on the rail and adjusts easily, up or down.
3. Bottom attachment with a hook that connects to any of the eight receiver attachments, at various heights, that are built into the PVC fender, for proper positioning. This hook design will attach to the aluminum molding around the bottom of the deck of the pontton boat.
4. A block of 6" x 6" x 1" E.V.A. foam with Velcro attached to the fender for easy adjustment and additional protection.

Features and Benefits include:

• It is a Complete System--There is no need to buy extra attachment devices or rope. On some of the newer pontoon boats you can not tie a rope for a fender around the top rail due to the one piece panels or the upholstery.
• No Need to Remove--Double hook attachment will keep the bumper from rolling around or popping up, there is no need to store the fender.
• Over 36" Long, Adjusts from 17" to 34" Attachment--Protects from above the top railing to 4 to 5 inches below the floor trim, or can be adjusted to protect the pontoons themselves.
• Protects Below the Water Line--This is the only fender that can protect below the water line and does not float up like typical round fenders would.
• Protects Above the Attachment Point--This is the only fender that can protect above the attachment point leaving no area for docks or boats to catch. Ropes and attachment points of typical fenders are normally the catch point for docks and can be both dangerous and damaging to the boat and passengers.
• Tapered Design--The shape of this fender sheds water and other objects off or away from the boat.